(http://i408.photobucket.com/albums/pp170/ktmgs/CIMG1084.jpg)
Which of these parts go on the 1968 early rear hub[?] thanks
Gooddirt,
I am assuming that you are working on a 4 bolt sprocket rear hub.
The ones I have use the chain adjuster on the left in your picture.
Are the two pieces on the lower right side of your picture the same, because they both look like the piece that goes thru the swingarm on the left side of the wheel with the chain adjuster fitting over the threaded part, then a nut goes on.
The spacer in the left front of your picture looks to be correct.
You have 2 pieces in the top right side of your picture, the one on the left looks to be the one that goes thru the sprocket carrier from the inside, I would need to take one apart to be sure and will do so if needed.
I have parts book 001 in front of me but it really doesn't help much on those hubs. If you need an 001 I have an extra one that is a reprint.
Alan B. should have NOS 4 bolt sprockets and possibly the rubber bushings.
Hope this helps.
Paul
Thanks, seems the lower right pair are the same and use a different size (bigger) nut than the upper pair on the right. The upper pair use the same size nut that are on the front hub 1972 for example . Iam still in need of a four bolt sprocket carrier.