Print Page - 1974 jackpiner clutch actuating arm

Title: 1974 jackpiner clutch actuating arm
Post by: fastwillie8568 on October 13, 2011, 11:36:06 PM

Can this unit be repaired, how do you replace the arm assembly if you purchase a new style from Al, or dose some one have a good unit for sell let me know. 330-774-4235 8am to 7pm est Bill Part# 51 32 013 399

Title: 1974 jackpiner clutch actuating arm
Post by: rob w on October 14, 2011, 09:09:38 AM

Hi and welcome Bill,

You just have to knock the dowel pin out (from back), and the arm will come out.

(http://i52.photobucket.com/albums/g8/BobWardlow/bingcarbpartsphotos001.jpg)

Bob

The assembly actually uses two 6mm push rods, seen on bottom right of photo.

Title: 1974 jackpiner clutch actuating arm
Post by: fastwillie8568 on October 14, 2011, 12:22:34 PM

Thanks for the phone calls, every one told me to purchase a new one so I called Al and ordered a new one. Thanks again.

Penton Owners Group

General Discussion => Penton Talk => Topic started by: fastwillie8568 on October 13, 2011, 11:36:06 PM