Hi All,
Trying to sort out my brother's '73 JP, and I noticed on the front of the slide, at the bottom, a HUGE smilie that looks like it was machined that way. Am I correct, or is this carb REALLY wore out?
Mick
It is worn out. the more pronounced the smile, the more worn it is..Bing is a great carb, but rebuilding them is expensive. On my Maico's I will run nothing else. my KTM is another matter.
Give Bing international a call..
Thom Green,Still crazy after all these years!
76' 250 MC5 (orginal owner)
74'250 hare scrambler (project)
74' 1/2 440 maico
78' 440 maico
72' cr125 Husky (project)
93' RMx 250 suzuki
If that's the case, and considering the good luck I've had with Mikunis, I guess I'll look for a 32 mm Mic.
Mick
Before you ditch the Bing, you might want to a new needle and needle jet. It will not be like new, but may be manageable. Fitting a Mikuni -- it's a tight squeeze.
Ernie P.
Chattanooga, TN
after Bing Int. gets done with you the only thing with a smile will be that old slide :-))))
just had to get that one in there - LOL -
Mick,
try what Ernie said and replace the needle and needle jet, might just work out fine !!
good luck,
Mike Gallagher, NJ.
[email protected]
I had a 73 with Bing and the smile on the slide. I replaced it with a new one to see if it was affecting the bike. Couldn't tell any difference. Anyway, Bing International won't have the original slide. I got a correct new one from Jake Fischer.
Keith Meatyard