Text only | Text with Images

Penton Owners Group

General Discussion => Penton Talk => Topic started by: James Niebrzydowski on February 15, 2015, 02:00:49 PM

Title: sachs gear shift mechanism shimming
Post by: James Niebrzydowski on February 15, 2015, 02:00:49 PM
In the penton manual under rebuilding the engine on page 51 fig 112 it said install shims to selector shaft until flush with case  . where do you put these shims?
DO the shims go on top of the circlip ?  its a sachs 125 6a six speed.
Title: sachs gear shift mechanism shimming
Post by: gooddirt on February 15, 2015, 04:09:59 PM
free slide them on the on the shaft above the outer clip
Title: sachs gear shift mechanism shimming
Post by: James Niebrzydowski on February 15, 2015, 06:04:03 PM
Thanks gooddirt, I think I got the shifter set to equal to amounts of over ride going down from 4th gear to 3rd and back to 4th. On the bench the shifting is inconsistant sometimes I can go right thru the gears other times it just won't go into the next gear is this normal when the motor is not running? Also there is a neutral after 6th gear is that normal?
Title: sachs gear shift mechanism shimming
Post by: gooddirt on February 16, 2015, 05:02:08 PM
I could give you a call it's easier.
Title: sachs gear shift mechanism shimming
Post by: James Niebrzydowski on February 16, 2015, 06:08:47 PM
give me a call 814 683 4825
thanks
Title: sachs gear shift mechanism shimming
Post by: James Niebrzydowski on February 19, 2015, 07:52:30 PM
Thanks  gooddirt

James.
Title: sachs gear shift mechanism shimming
Post by: VICTOR MONZ on March 20, 2015, 07:42:35 AM
Good Dirt.

Give me a call.  Need Parts.

Victor
Title: sachs gear shift mechanism shimming
Post by: gooddirt on March 22, 2015, 08:09:38 PM
ok will do.
Text only | Text with Images