hey don't laugh to loud but does anyone have any leads on a crankbearing for penton 400 fag 25.and I would like to have a standard bore sleeve if possible.might have to sub sleeve for oversize piston.any ideas would be appreciated.have checked about everything on the internet.thanks rich
rich skeweris
Call Al Buehner on the suppliers page for bearings or contact Gary Ellis on this site if Al is out of bearings, and discuss with Al an exchange cylinder if he has any. Mike
Michael R. Winter
I enjoy rebuilding and appreciating Pentons!
1974 250 HS Pentons-1978 KTM 250'S
1975 Can Am 175 TNT 250 conversion
1976-78 125-400 RM's & 79 PE250 Suzuki & 2012 DR650
2007 CR125R Honda
1977 MC250 Maico
thanks Michael.talked to al few months ago but will check again.
rich skeweris
Just use a regular bearing.
Brian
Yea got the numbers off of a fellow who rebuilds a lot of them last nite.still searching for parts for top end.thanks
rich skeweris
Gary Ellis had some of those bearings imported. They were good quality bearings, but I'm not sure how many he has left. He also has a lot of engine parts so he might be able to help you out with the 400 top end. Gary 217-260-0237. Mike
Michael R. Winter
I enjoy rebuilding and appreciating Pentons!
1974 250 HS Pentons-1978 KTM 250'S
1975 Can Am 175 TNT 250 conversion
1976-78 125-400 RM's & 79 PE250 Suzuki & 2012 DR650
2007 CR125R Honda
1977 MC250 Maico
Rich
I might still have a 400 cyl head and can take a look if it's a part you're looking for. Let me know.
Dave McC