Looking for a stainless reproduction engine guard/skidplate like Al used to sell. Will buy or have a nice intact stock one to trade with. Call 217-414-2295 or email
[email protected]Larry P
Found one. Thanks to a super guy!
Larry P
Does your super guy have any more?
I would like to just see a good photo of one! Were they made of a heavier material than stock, other than being stainless? The stock units had the little flanges on the holes that were supposed to make the pan stiffer and stronger, I'm guessing, but a little thicker metal and being a 304 stainless would go a long way and not be too expensive. If I could get accurate drawings, I think I could make one even in my garage.
Type at you later,
Dan McEntee
Daniel,
They are thicker. Send me your email and I will get pictures for you.
[email protected]Larry P
Hey Mr. Good dirt, can you send me some photos?
[email protected]
Correction carldoughill@yahoo. com
Does it still look good? If so I will likely take it. What part of the country do you live in?
Have one on mine,Very strong,thicker but looks like it belongs there.
Larry,
If Carl does not want it I will take it. I am going to try and get them remade.
[email protected]Larry P
Go ahead and get it if you are going to use it for a pattern. Let me know when you get them made and I will buy 1-2.
Would Penton Owners prefer Stainless Steel or Aluminum construction Skid Plates ? All Custom Fabricators will produce a limited production run and furnish them to Al Buehner for resale based upon preferences.
I vote for aluminum
Karl, Thanks for doing that. I think Aluminum seems the way, whatever my vote is worth. It is what is going on my Rocket Bike. Appreciate your help now and in the past. You de man!
Larry P