Print Page - PVL Testing

Title: PVL Testing
Post by: imported_n/a on September 27, 2003, 08:03:10 PM

Will Penton Imports take an ignition for testing from an individual? I know they won't sell directly, but I hope I don't have to go through a shop for testing.

Title: PVL Testing
Post by: Lew Mayer on September 27, 2003, 08:08:52 PM

They sure will and they're very helpful people.

Lewis A Mayer

Title: PVL Testing
Post by: firstturn on September 27, 2003, 10:25:07 PM

The have been helpful on PVL and Motoplat testing. They can also re-magnatise your flywheel if needed.

Ron Carbaugh

Title: PVL Testing
Post by: imported_n/a on September 28, 2003, 07:55:18 AM

George, give Dane Leimbach a call at Penton Imports to arrange for testing. You may not want to hear your Motoplat is dead or weak, but prepare yourself for it.

Glenn

Title: PVL Testing
Post by: imported_n/a on September 28, 2003, 11:45:33 AM

Glenn,

Its not a Motoplat, it is a PVL that is having problems. The stator fails the resistance test outlined on Penton Imports web site. I am prepared for the worst.

It is good to know that I don't have to go through a dealer for testing.

George

Title: PVL Testing
Post by: imported_n/a on September 29, 2003, 08:56:36 AM

George,

Sounds bad! Give Dane a call.

Glenn

Title: PVL Testing
Post by: imported_n/a on September 29, 2003, 02:22:20 PM

Actually it turned out fine. While removing the stator, I noticed that one of the wires felt funny. After splitting the harness the wire turned out to be broken. After splicing the wire the Deek fired right up.

Penton Owners Group

General Discussion => Penton Talk => Topic started by: imported_n/a on September 27, 2003, 08:03:10 PM