Print Page - 125 internal roter ign

Title: 125 internal roter ign
Post by: Mike Lenz on January 12, 2004, 10:55:18 PM

I am looking for an internal roter ign for a 100/125 for my 100 project. Can anyone help? Buy or trade.
Thanks

Title: 125 internal roter ign
Post by: Doug Wilford on January 13, 2004, 04:58:02 PM

Mike; The PVL is an internal rotor, it has advantages over the old motoplat. I see some on E-bay for $310.00 not a bad deal.

Title: 125 internal roter ign
Post by: Mike Lenz on January 15, 2004, 10:30:12 PM

Thanks Doug. This is a 175 project for my son and I was hopeing to find a Motoplat internal for about half that, if can. Do you know how much the PVL,s run new? Also how are they they better?
Thanks alot
Mike

Title: 125 internal roter ign
Post by: rob w on January 15, 2004, 11:20:23 PM

I know a Husky guy (meaning cycle brand, not his size), not to long ago he mentioned he had some internal rotor Motoplat's that he'd never use. Will one that's made for a Husky work? I'll try to reach him and find out what he's got there. I'd guess they were for Husky CR125's. Not sure.

Title: 125 internal roter ign
Post by: Doug Wilford on January 16, 2004, 04:06:34 PM

Mike; The PVL has a much lower spark threshold. Motoplat is about 800-850 RPM to produce spark. PVL is and I am not positive of the figure more like 550-600 RPM I do know it has a much lower threshold, the PVL is also stronger through the range. I will have to get Dane to give you the advantages. I don't sell them. The Sachs engine has a kick RPM of 12- 1400 RPM but most other engines are only around 800 - 1000.

Title: 125 internal roter ign
Post by: Mike Lenz on January 18, 2004, 10:46:45 PM

Im sorry I see I confused everyone. The project is a 100...but with a 175 lower end mated to a Sachs cyl, so I need a KTM ign.
Thanks

Title: 125 internal roter ign
Post by: Dennis Jones on January 19, 2004, 08:10:00 AM

I have an internal rotor motoplat that I don't know what it fits. It came with a 125 I got but does not fit a Sachs. A friend tried it on a Montesa and Husky but did not fit. I tried it on a 250 Penton, the backing plate fit but not the rotor. Would a 175 crank end be different?

Dennis Jones

Title: 125 internal roter ign
Post by: Mike Lenz on January 20, 2004, 09:00:50 PM

Thanks for your help but the 175 has the same crank end as the 250.
Mike

Title: 125 internal roter ign
Post by: DKWRACER on February 01, 2004, 12:41:10 PM

Mike, I think I found an internal rotor motoplat, fits 250cc motor taper, maybe fits 175 taper too?...Tom.........

Penton Owners Group

General Discussion => Wanted / For Sale => Topic started by: Mike Lenz on January 12, 2004, 10:55:18 PM