I'm looking for a close up photo of the expansion chamber mounting tab under the right side of the seat. I believe the tab was just about ¾-1" long and just about as wide with a hole in the center for mounting the rear section of the expansion chamber. Mine broke off and I need to fabricate a new one. Does anybody have a photo or exact measurements of this tab? This is for a 1970 steel tanker.
The alloy tri-clamps and headlight mounting hardware on my bike are like a transparent gold color. I believe it is some sort of clear coating that yellowed over the years. Were these items intended to be aluminum color with a clear coat, or are they in fact a goldish color. The same with the aluminum fork legs – they're not the same goldish color as the tri-clamp and headlight mounts but they look like they have a clear coat on them. Do they? Is there a grain on the fork legs (up and down or side to side) or are they lightly polished w/o any visible grain?
Thanks-
Peter Kane
V3442
Plainville, Massachusetts
PentonSixDay@Gmail.com
Peter, Have Al cut one (exhaust bracket) off an old frame he has and ship it to you. I just had him cut the rear section off a frame for me so he should have a left over part for you with a little luck. I also had him send a rear gas tank mount for the steel tanker. The aluminum parts you refer to were silver with clear coat. I normally blast mine to natural and just clear coat them. The fork legs polish up nicely with Jewlers Rouge (sp) and a cotton wheel. Don't make them too pretty!