Does any one make sets of stiffer 32 mm springs for the Ceriani front ends?.
Dirk
Dirk,
I am not sure if anyone makes what you want, but really all you have to do is purchase valve springs for a small block Chevy engine and cut them to the length you want. You will have to experiment with different lengths to get the results you want. I hope this helps...just my take.
Ron Carbaugh
Thank's Ron I'm 230 on a good day, so I'll start at about 1 1/2 and work my way back towards 1 inch. I can get the valve springs from my high school auto hobby shop.
My concern would be coil bind in anything over that longer length.
Dirk Williams
Dirk,
You don't have to put a spring in if you are concerned about binding. You can put a solid piece of metal...not PVC or plastic for obvious reasons. I would stick with the springs and always put the cut end on top to where the spring mounts flush with the original spring. I hope this helps.
Ron Carbaugh