Would like to find a nice radial fin head that has same contour as cast iron cylinder. For a 125cc steel tanker. Someone in Europe have them but shipping is 4x price of head. Thanks, Ted
i think the puch radial head may work, but as usual i have so much going in and out of the noggin i may have this backwards.i'd check with doug wilford as we discussed this not long ago but i've slept since then so the answer i could give you would be a bad guess.check with doug,he'll know for sure! Merry Christmas, Ric
ric emmal
A Puch high compression head works but it is larger than the cylinder.
Lew Mayer
Hi T20sl, I think I have one of those heads, there much smaller than the porky pine ones right ??
Raymond
Down East Pentons
Raymond: Yes they are much smaller. Can you email a picture? They are also slightly taller at the front than at the rear. Puch head is different, I had one but sold it as it was not correct to fit cylinder profile. I have several of the large aluminum cylinder heads if you need one. Thanks, Ted
[email protected]
If you go to the photo gallery and look at the pictures from the 2005 POG/KTM display pictures # 9 & 16 are the Puch head and pictures # 12,19 & 20 are the Sachs head.
Paul
Hi Ted, I found the head I thought was for a Sachs cast iron barrel, but its not. It has 6 head bolt holes in it.
I'm not sure what it fits, but it does have a big M with an insigna of sorts on it ??
Good Luck with your search.
Raymond
Down East Pentons