hi all, i'm looking to buy a inner race puller for the crankshaft main bearings on early ktm motors. anyone have any leads on where i can get one? [?] thanks, chijer
The SACHS puller (will also work for KTM) tool is the same for all the inner races but the puller shells are different for each size bearing inner race, i.e. M-20, M-25, etc.. Last time I was at Jakes in P.A. he had some but of a little different type. Al Buehner may have a few left over but not sure. I have also found them on EBAY under snowmobile tools or under "SACHS". CIAO
thanks, kip. i checked with al and he doesn't have them. i will keep looking and will purchase a sachs tool if i can find one. i could have the collars machined easy enough if i had a pattern such as the smaller diameter ones for the sachs bearings. thanks for the info.
jerry
Let me know when you find one chijer. I need one too !! The crank bearings are just to delicate to succumb to caveman style techniques :(
Raymond
Down East Pentons
If you dont mind Chinese ,Harbor Freight Tools has a devise for the races.I dont know what they call it or the part number but its two blade like jaws that you crank down upon.You would set it up behind the races.
Hello, Im new to the group but have a 72 six day I restored a 4-5 years ago. You can pull the outer races without a tool at least I did but the way I did it I ruined the race but as I see it the only reason you would want to pull them is to replace anyway. I also pulled the inner races without any special tools and since I reinstalled new bearings/races I have ran my 125 for several years with no problems. Email me if you want the details
[email protected] .
Curtis
curtis
i have a original KTM puller with the two half shells for M 20 and M 25 bearings for sale. i could also sale only the two half shells spearately if there are interests. its all KTM original tools! my email is:
[email protected]