What would you use if these are not available? Bing had them, but no longer. Carb will not fit tight without this.
Steve Clay
76 250 Penton/73 Harescrambler
76 husky 250 WR
2002 Aprilia Futura
71 Honda Trail 90
And if you find one, perhaps someone here can confide the secret in getting it affixed!
I carried one in my spare parts for years because I couldn't get it to fit on the spigot, even though it fit fine without the carb, and fit fine in the carb!
JE
Buy Felpro sheet gasket material (pick your thickness) at Auto Zone or your favorite jobber. Cut to your desire. If you want it glued, use Loctite glue to secure the ends together. CIAO
thanks, I'll try the gasket material
Steve Clay
76 250 Penton/73 Harescrambler
76 husky 250 WR
2002 Aprilia Futura
71 Honda Trail 90
I seem to remember that there was also a fiber washer that fit inside the carb before you install the bushing? Does that ring a bell? Gavin
Gavin is correct about the fiber washer. What size bike (bing) are these for? I have the fiber washer for the Sachs and 2 different sized bushings.
Donny Smith
Paragould, AR
I used the gasket material and it seemed to work, I didn't put in the washer. The bing is a 36mm I see it listed in the manual, but it didn't have one in it. I'll start it today if it warms up.
Steve Clay
76 250 Penton/73 Harescrambler
76 husky 250 WR
2002 Aprilia Futura
71 Honda Trail 90