Just bought a 4 gallon Malcom Smith off Ebay and found the threaded insert for the petcock was missing. It was the KTM/Husky 4 gallon tank and I wonder if any of you would have a suggestion on how I could rig up an insert/petcock. Those tanks were to use a stock Husky or KTM petcockbut as long as it works, I don't care.
Glass, steel, aluminum or plastic tank ??
Raymond
Down East Pentons
Plastic tank. Approximately 9/16 inch hole on petcock side, I am missing the threaded insert that was to be wire guided to the hole with an o ring inside the tank. There are no mounting holes (as with a Clarke) on either side of the hole.
83husky250,
I've seen some aftermarket plastic tanks that have a grommet that you push into the hole, and then you push the petcock into the grommet. Some Can Am's used this same setup. I'm not sure if this one is the correct size or not, but it's available from RTR Moto (//www.rtrmoto.com) for $19.99.
(http://www.rtrmoto.com/photos/petcock_kit.jpg)
Gary
I have a Winsor tank for a 77 GS6 that uses this set up.....It's a spare and I've never put gas in it so I can't swear it doesn't leak. I do know it's a very tight fit though.
Steve Minor
Wilmington, NC