Messages

KTM Is Sold TY

Larry did you find out about the parts???


Thanks:

Tom

Hi Larry:

Yes I need a 125 MX frame. I will be at Harper's this weekend riding the mighty Hodaka. What did you want for the frame if it's the same? Sounds good will have to meet up.

Thanks:

Tom

I agree 100 percent. If you want to come to MOVMX event this is the one.  This is the biggest of the year. Great times for the whole family. Curtis really puts on a great event.


Tom

Thanks for the help Big Mac.

IS the frames on a 85 and 86 KTM 125 the same as the 84 MX? What differences are on the 250 frame they look the same by looks.


Tom

Also looking for a clutch holder. Any After MArket ones out there that work for this model?


Tom

Thanks Gary will call on Wed if thats ok to see when is a good time to come up.


Thanks:

Tom

Thanks Brian will be calling Gary to see when I can come up there.

Wanted to know if anyone had a clutch holding tool for the 125? Or what did you use to create one? Started dissassebling the engine to check bearings and seals. Long way to go. Anyone have a good source for lower end gasket set?

Thanks


Tom

Brian:

 What are the prices for the complete new seats?

Thanks for the info.


Tom

THat s a pivot boly that goes through the frame and swingarm.

Thanks:

Tom

Gary:

 Do you have the parts manual for the engine for the 1985 and 1986 engine?

Also what would be the shipping for the MC Frame to Missouri? And do you have a nice swingarm bolt?

Thanks:

Tom

Hi:
New to the Forum and would like to know if anyone has a 1984 KTM 125 project for sale? Would also manual/parts list etc. Appreciate any help on this project would be appreciated such as parts sources and availabilty?

Thanks:
Tom From Missouri

Up For Sale is a 1984 KTM 125 MX Project. Picture is before bike was taking apart. Does not come with a piston. 350.00 for the bike by itseld or 500.00 with the NOS parts I have purchased which as follows:

1. NEW Clutch/Water Pump Cover
2. NEW Throttle Cable
3. New Airbox to Carb Rubber Boot.
4. New Three gaskets for engine

Great start for someone. Prce is reasonable and firm. Will not sell NOS parts Seperate until bike is gone. Buyer will have chance to get the whole deal first. Will Be listed on Ebay If not sold on here.

Thanks:
Tom

Will 84 KTM MC250 clutch and primary work on a 84 MX 125 engine?


Thanks for the help.


Tom