Messages

What I have is a 36 for Radaelli Chrome wheels that came off at 1972 six day bike. The wheels are rusty but straight no major dings are dents. Since chrome plating is expensive my thought was just to have them powder coated and use them on my next project. There are spokes that come with it but not a complete set.

I am thinking that my problem is less carburetor issues and more engine seal or gasket leak.I am going to try all the suggestions from the other members,but check the seals and gaskets for leaks first.

I would like to thank everyone for all of their help, support, and suggestions. I will definitely try them all until I get this mystery solved. It's great to get suggestions from experienced individuals that give me direction of where to go next. This is a great website to be able to learn from experiences from other members. I will keep everyone posted on what worked in my case.

It starts and runs for 10 seconds then goes lean (Big Time) and quits. I did a total rebuild about 4 years ago including a carb cleaner soak. it was better but not right. Both the needle and seat were changed at that time. I didn't change the slide and will do that next. Also, does someone make block off plates to pressure check the engine for air leaks?

No Thanks ,I am trying to keep all the original parts I take off and pass them on to the new owner when I eventually sell.
Originally posted by Rick Bennett[/i]

I will trade you a Mikuni for the Bing.
Rick 440-417-8094

[email protected]


Ron Carbaugh

[/quote]

Thanks Ron,I am interested send me a picture.

Hi I'am looking for the right side engine case (motoplat side)for a Sachs 6B 125cc with speedometer parts.

Thanks everyone for your advice. Now I can move forward with my restoration project.

Thanks for the info.I ride my Penton almost every day (around my house and down city streets). I was considering restoreing it ,and wanted to keep it as oringal as possibe. I'll have to start looking for fenders and parts at swap meets.

I have a 1972 Six Day 125 cc. I am tried of messing with this bing carburetor. I want to put a Mikuni on it but im not sure what size or where to buy it? Any info would be helpful.

Have 2 Radaelli rims that came off a 1972 Six Day 125. They are straight, but of course they have some rust,no dents.Also some spokes but not a complete set.  .$ 50.00 or Best offer . I live in North Canton,Ohio

Hi I'am looking for the right side engine case (motoplat side)for a 1072 Sachs 6B 125cc with speedometer parts.
Go to
 

I am looking for someone with a precision Hone to hone my Sacks 125 cylinder. (Hone with four stones not a Ball Hone)  and also tell me what size piston I need.

My Penton has a metal front fender, but has a plastic rear fender? Was the rear fender suppose to be metal in its 1972 bike.