Messages

JAKE  Thanks for your response.    But  I Need  140 MM. Center To Center Rod  Length.   John

Thanks Gary for the information,I  will send them a email ,

Tom.   Thanks for getting me the  needed parts, john

I checked with Al .  Bearing not available ,    I need the 1 piece rod with  bearing on the end, on the parts  diagram.  I need  number 030 and  number 33    The Push rod with cup and the  tiny bearing cage , thanks for the response, john

Tom.   Thanks for getting me the  needed parts, john

I checked with Al .  Bearing not available ,    I need the 1 piece rod with  bearing on the end, on the parts  diagram.  I need  number 030 and  number 33    The Push rod with cup and the  tiny bearing cage , thanks for the response, john

N/A wrong year

quote:Originally posted by Canyon

Wanted to buy the following parts for a 200 jackpiner .  Factory seat cover or complete seat,and set of fork tube protectiors, Thanks john text or call me at 570 419 3661

I restored my fenders ,using a small hand held sand blaster from harbor freight,  with compressed air,with arm and hammer baking soda,,  bought the big bags at Sam's Club, then  wet  sanded them with fine sand paper, then  fine steel wool,   Then 2 to 3 coats of plastic renew,  the looked like  new when done.. you can also  soda blast your engine cases and cyl head and cyl. And they look very nice.  Good luck with your project. Thanks john

Thank  you,   Al ,Gary and Jerry for your help on the crankshaft  identification ,   Greatly appreciated!!! Thanks  John

Curtis museum  very cool place to  visit in Hammondsport ny , it's has a wide verity of  motorcycle, planes, boats, and other interesting  motor related  displays, well worth the  time and trip, be sure and check out   The Glenn  Curtiss 8 cyilinder motorcycle that he built in the 1907 era  that set a land speed record 136.4 mph.  I also believe that mr Curtis  built the first twist throttle system for motorcycles, they also will have a nice verity of off road and on road vintage motorcycles on display.

Matt at core graphics  is able to reproduce the 1997 jackpine Graphics's you can contact him at 336 818 2888  ask for Matt

   SOLD

WTB. Looking for a  1990  ktm 350 connecting rod kit ,for a ktm I am restoring,  rod kit is the same as  ktm 440 and 500 and 550 motor. Ktm part number 565 30 215 044 or part number 565 30 015 044  ,    Call or text me at 5704193661 thanks john

Looking for  the following parts , 2 plastic  white preston petty headlight mounting brackets ,the ones that clamp around the fork tubes to the back of the headlight, also looking  for 1 of the small  triangular brackets that mount the  handlebar speedo mount to the crossbar.  Thanks john