Hey guys,
If there is enough demand, I can reproduce rubber parts for bikes, like air box boots, intake manifold/carb connectors, etc. I don't own a Penton or KTM, so I'm not in tune with which parts are hard to find, but I know that in general, rubber air box boots are hard to come by for most old bikes. I have just made airbox boots for Montesa VR and later models, and it went extremely well. For me to break even, I typically need to be able to sell 100 parts at $25 to $30 each. All I need to get going is one good reference part to measure and produce a CAD model from. Let me know if anyone thinks there is need, and whether there is enough demand. Thanks!
If there is enough demand, I can reproduce rubber parts for bikes, like air box boots, intake manifold/carb connectors, etc. I don't own a Penton or KTM, so I'm not in tune with which parts are hard to find, but I know that in general, rubber air box boots are hard to come by for most old bikes. I have just made airbox boots for Montesa VR and later models, and it went extremely well. For me to break even, I typically need to be able to sell 100 parts at $25 to $30 each. All I need to get going is one good reference part to measure and produce a CAD model from. Let me know if anyone thinks there is need, and whether there is enough demand. Thanks!