Installing new seat cover...

[JamesHorwatt]

Good afternoon, Looking for input on what types( brands )of contact cement everyone is using when installing seat covers. I purchased a reproduction one from Al B. and per the instructions it calls to be glued on. In the past I've used my air stapler and it worked fine, But will not pierce the reproduction fiberglass seat pan I have. So I guess I'm going to be gluing it on.



Thanks Jim

[Cal Alexander]

I have used various brands of contact cement available in hardware stores with similar results. Seems that plenty of set time with the contact cement before you secure the cover to the pan is the key to getting a good bond. Don't get in a hurry.

Make sure the cover and pan are warmed to at least room temperature or a little more. You can use a heat gun (be careful) or a hair dryer to heat the cover up slightly so it will stretch more easily.

I generally use some small clamps along the rear of the seat to hold that part of the cover secure. Leave the clamps on overnight to allow the cement to fully cure.

[Carl Hill]

I used gorilla glue on mine. Seemed to work ok

[skiracer]

On my mc 5 fiberglass pan, and on my XC metal pan I use sheet metal screws with small washers.  The screws bite very well into the pans, and along with quality contact cement, I have have not had any problems. As a note, these bikes are raced regularly, and are not show bikes.....

1976 250 MC5 Original Owner
1976 Penton 175 XC

[Toolsurfer]

I Used Permatex headliner/carpet adhesive and also have used 3M headliner adhesive . Follow instruction on can for spray. As said earlier, I got mine warm as to stretch and have no wrinkles so it looks oem . Clamped mine over night with plastic closepin type clamps. After total dried I also installed a few 1/8 in. aluminum rivets in stress points were there was no chance to harm cover or wear a hole prematurely. Looks as good as any I've seen. Not rocket science just take your time to prep so it  comes out looking good. I'm sure there are many other ways you could try. Good Luck William

[Mick Milakovic]

+1 on letting the glue set.

Mick