Spokes

[crheeterman]

Getting ready to buy some NOS spokes for a '73 Jackpiner project. Jackpiner Parts list for the Rear wheel calls for "36 count – part # 51-10-071-000" spokes and doesn't specify "inner" and "outer".  Does this mean that all the spokes are the same?  Or do half of the spokes (18) need to be "inner" and the other 18 "outer", each set of 18 with a different bend of approximately 45 or 90 degrees at the hub end?  Seems like there should be or have been separate part #'s for each type re "Inner" vs "Outer"?  Or, does "Inner" & "Outer" in fact refer to the lacing pattern re "cross 2, 3, etc."?  On the other hand the JP parts list for the Front wheel does in fact refer to "Inner & Outer" spokes but again the part number is the same for all 36 spokes - 51-09-071-100. When ordering/searching for these spokes do I need to specify a separate part # for inner and outer spokes and/or bend ?  In other words, does the bend determine whether or not the spoke is inner or outer? Thanks, Chris  

[Larry Perkins]

I have quite a bit but need measurements as they are not all part numbered.

Larry P

[Dale Fisher]

Walridge has Penton sets in galvanized and stainless.  All 36 are the same, the outers just need a little tweaking with a rubber mallet.

http://www.walridge.com/





Dale Fisher
Penton Owners Group - Memberships - POG Merchandise
Mudlark Registry
Facebook - Penton Owners Group - Administrator
Facebook - Cheney Racing Group - Administrator