Engine brace

[Rocket]

I am looking for an aluminum engine strut for a 75 Jackpiner.  I believe both sides are the same.  I have one and it measures 10" overall length, 9" c/c on holes, one hole is 8mm and the other is 10mm.  Any help would be appreciated.  Also looking for the oil level check bolt for a KTM motor.
thanks
Rocket

[DKWRACER]

Rod, I think I have, let me get back to you, will run out to the shop...Tom....

[DKWRACER]

Have two...
10in. LOA.. at 9in.. cc 8 and 10mm holes
915/16in. LOA...83/4in. cc 8 and 10mm holes
Can contact me off-list if interested
Adios, Tom...

[Mike Lenz]

There is a small differance in the lengths. The right one is 225mm center hole. I am also looking for that brace.