jackpiner clutch plates

[Dale Sonnenschein]

Is there anywhere I can buy new clutch plates for my 73 piner? The clutch works good but it rattles a lot. The ears on the plates are worn.

73 Jackpiner
73 Husky 360 WR/RT
76 Husky WR360
78 husky cr250
10 ktm 250xc
02 bmw r1150r

[KJDonovan]

Dale,

I see some here.  http://www.enduroklassiker.at/en/clutch-parts/2522-kupplungslamellensatz.html  

Thanks,

Kevin

[DKWRACER]

Dale, if those are the sintered plates, I may have a set, will ck.
Tom Brosius
[email protected]

[Dale Sonnenschein]

Thanks guy's.
Tom, I'm not sure what I have or how to tell what I have. The clutch makes some noise. It looks like the two inner plates were changed as they look good and fit tight in the basket.The three outer plates have about 1/16" gap and you can see the ears are worn. I appreciate the help.

73 Jackpiner
73 Husky 360 WR/RT
76 Husky WR360
78 husky cr250
10 ktm 250xc
02 bmw r1150r

[DKWRACER]

Dale I did locate three bronze colored plates (2.3 mm), I also have the fiber composite plates at 3.3mm thick ( angled pads)..
Tom Brosius

[Dale Sonnenschein]

Tom, I don't know what I have and I probably won't have time to take it apart to look before VMD. Can I contact you after VMD?

73 Jackpiner
73 Husky 360 WR/RT
76 Husky WR360
78 husky cr250
10 ktm 250xc
02 bmw r1150r

[DKWRACER]

Yah, sure...Tom

[1973_ Jackpiner_175]

There is a complete set of metal and fiber on eBay; item number: 171819291623. Just cut and paste this in your search box.

[gooddirt]

most likey its the clutch bearing, they go out before most bearings a bit weak.

[Dale Sonnenschein]

So how do I check the clutch bearing? I had the case off a few weeks ago and I tried to wiggle the basket but it was tight.

73 Jackpiner
73 Husky 360 WR/RT
76 Husky WR360
78 husky cr250
82 husky wr430
10 ktm 250xc
02 bmw r1150r