sachs gear shift mechanism shimming

[James Niebrzydowski]

In the penton manual under rebuilding the engine on page 51 fig 112 it said install shims to selector shaft until flush with case  . where do you put these shims?
DO the shims go on top of the circlip ?  its a sachs 125 6a six speed.

[gooddirt]

free slide them on the on the shaft above the outer clip

[James Niebrzydowski]

Thanks gooddirt, I think I got the shifter set to equal to amounts of over ride going down from 4th gear to 3rd and back to 4th. On the bench the shifting is inconsistant sometimes I can go right thru the gears other times it just won't go into the next gear is this normal when the motor is not running? Also there is a neutral after 6th gear is that normal?

[gooddirt]

I could give you a call it's easier.

[James Niebrzydowski]

give me a call 814 683 4825
thanks

[James Niebrzydowski]

Thanks  gooddirt

James.

[VICTOR MONZ]

Good Dirt.

Give me a call.  Need Parts.

Victor

[gooddirt]

ok will do.