Messages

Thanks for the info, will proceed.

I think my hubs may have had a clear coat that wasn't very durable, compared to the rims. Did you do any prep work, like polishing or glass beading your rims? Do you have the name of the business? I wonder what the original color was on Sun rims, probably silver or aluminium ?
Thanks for the reply.

I should have mentioned it is an off topic question. I was hoping someone had experience re-coating the rims.

I could use a 73 large tank like the one pictured if anyone has one for sale or I would trade a small tank .Thanks,Dan

Thanks for the information,I contacted Mike.Brian, send me an email so I can contact you. oleebmw@ aol.com ,remove one of the e from my address. thanks,Dan

Thanks Brian, I sent Mike and Rokon Ron a message and both didn't deliver.I Must have forgot the stamp.
I'll send you a PM  Dan

Do anyone have a steel rear fender [like the one in the brochure gooddirt posted] for sale. Mine appears to be chopped off several inches. A chrome plated one would be ok.

Sounds good,keep looking.I could use a better cylinder also.If anyone is interested I have a right engine cover #0211 127 399 to trade for the one I need. It is very close to the one I need, but about 1/8" larger along the bottom Thanks,Dan

AMEN

Thanks for the info John,I'll check it out and let you know.
Thanks for the side cover offer Gooddirt,I'll send you an E-mail.
                                                                Dan

I need to re-anodize the scratched and dinged rims and hubs on my restoration. I know there is different grades of hardness. Some can be removed with TB cleaner, others take a lot of chiseling with a sand blaster.  Any suggestions on who to use to get the original type of finish??

Would anyone have a seat or seat base for a 1976 Monark 125 Enduro that they would sell? Also need the chrome steel front fender and mounting bracket. Thanks.

This is not Penton related,but I thought I'd ask anyway. I can't seem to contact any of the Rokon parts dealers listed on the Rokon group site. Does anyone have any contact info? Thanks Dan

I need the above cover for a 80 cc engine. The part number on the inside should be 0211 127 200. It is for a 1967 Hercules Boondocker.I also need some measurements to fabricate the exhaust as all I have is the head pipe. Anyone in this group have one of these bikes that can take some measurements? Thanks,Dan

I need the right side engine cover for a 1967 Sachs Boondocker 80cc. The # inside the cover should be 0211 127 200. I also need a flywheel and magneto parts,exhaust and an original headlight. I havn't looked inside the engine so I will probably need some internal parts. Anything out there? Thanks, Dan