Messages

Thanks Kevin,
These must be for a Penton.


Michael Murphy
Preston Petty Products
1978 400 MC-5
[email protected]

I am interested in that trailer.

Michael Murphy
Preston Petty Products
1978 400 MC-5
[email protected]

Larry, we did answer your question earlier.

Larry to answer your question why we have not yet made the MX rear fender is because of tooling costs.The 3D design work to build the tool is already done and ready to start but we need to sell a lot of the MX Front fenders to help pay for the tooling for the MX rear fender. To do it right is not cheap but it will also be an exact copy of the original once completed. It is next up to produce.
Thanks guys
Paul




Michael Murphy
Preston Petty Products
1978 400 MC-5
[email protected]

Hi Dale,
I really appreciate the post. Couldn't work with two better people
than Paul and Preston.It's great to see all our hard work come to
fruition! It's been a great ride so far!



Michael Murphy
Preston Petty Products
1978 400 MC-5
[email protected]

We have them back in stock. //WWW.PrestonPettyProducts.com


Michael Murphy
1978 400 MC-5
Many Rokons
[email protected]

You have a good memory Dale. See how things go in full
circle in life, now I'm repaying the favor.



Michael Murphy
1978 400 MC-5
Many Rokons
[email protected]

Dale,
Send me your address and I will give you one. Early Xmas
present. I have new ones just sitting here.
[email protected]



Michael Murphy
1978 400 MC-5
Many Rokons
[email protected]

Dave,
Email me what parts and stuff you have.
Thanks,
Mike
RT340AUTO at aol dot com



Michael Murphy
1978 400 MC-5
Many Rokons
[email protected]

Thanks guys. Roy, you can contact me about a Rokon at
RT340AUTO at aol dot com
Mike



Michael Murphy
1976 250 MC-5
Many Rokons
[email protected]

Jerry,
Sent you a PM, check your mail.

Mike



Michael Murphy
1976 250 MC-5
Many Rokons
[email protected]

I'll take the boots if Mike is going to pickup the tank for
Dan since I am also going to York.





Michael Murphy
1976 250 MC-5
Many Rokons
[email protected]

Steve,
Email me direct about your VDO drive.



Michael Murphy
1976 250 MC-5
Many Rokons
[email protected]

Steve,
I have over 30 used ones. I will give you one, need the numbers
on yours so we get the correct ratio, hopefully I'll have the one
you need.




Michael Murphy
1976 250 MC-5
Many Rokons
[email protected]

Doug,
Do you have a picture of what you need? I have atleast 30 used
and brand new VDO speedometers with and without brackets. I'm
sure one of these brackets will work. They came from a old
vintage enduro shop we purchased.

Michael Murphy
1976 250 MC-5
Many Rokons
[email protected]

I have taken pictures of the sliders, if you email me, I can
send them to you. I found 2 pair, both the same. They look to be
model C-1000, they have the tabs,15 inches long,and have fork wipers. I will slide one of my betor tubes in and see if they
are 35mm.



Michael Murphy
1976 250 MC-5
Many Rokons
[email protected]