Messages

Joe

I just posted a 1968 Berkshire 100 on ebay item #270115120246.   OOpps don't spend too much time here at POG so I forgot about the "for sale section".    Good Luck  Dom

Dom

Hi Tom
Nice to hear from you.   I did receive the VMCR party invitation .... thanks.   I can't make it this year but may I send a few mason jars with refreshments inside?  

er ... hmmmm .... I'm talkin' jelly here!!!!!

say Hi to the gang for me.

Later

Dom

Dom

Hi Doug

I retired to central TN (Cookeville) about 2 years ago.  Don't currently own a Penton but ocasionally stop by because I really enjoy this site  ....did a lot of vintage MX (14 years)in the Rocky mountain region on Huskys and K-wakers.   ..... currently building an Ossa Plonker ... gave up the "go fast" stuff (for now).  Also got a couple of CT90's so we can go to the "holler" and suck some suds.   Y'all come on down.

Dom Dominik
Bloomington Springs, TN

Dom

OUCWBOY

...been watching this site for two days .... Your guys are obsessed!

.... I'll try to round up some 72 – 74 frames for measurements ... any volunteers?    I'll pay postage both ways.

Thanks

Dom


Dom

Monty, Glenn, metalkfab, Rob
Thanks for your interest and quick replies.

AHRMA Eligibility .... both "DG" and "Crossup" had aluminum swing arms "pre 74" .... I have photos.

Rob ... thanks for the compliment  ... we spent 6 months in design and test.   Also, please read through the web site pages ... there are options for bearing materials from hard aircraft quality nylon to needle bearings.

As for the shock mount it was designed to allow for custom location.   Shock mount location flexibility was one of the "must have" design features for our swingarm products.

Currently we do not have a design to incorporate multiple holes along the swingarm.    However is the interest and commitment ($$$$) are there VMXpert is ready.

Again thanks ... I hope this info helps

TBC (to be continued)

Dom
VMXpert PP

Dom

Any of you Pentonites interested in aluminum aftermarket swing arms?

My name is Dom Dominik and we at: //www.VMXpert.com
are getting ready to develop our next group of swingarm products.
I'm soliciting your input as to what Penton models would be candidates for aluminum swingarms.    Also, what swingarms are common to several models ... if any.
Last ... need POG expert contacts to answer questions.

Thanks

Dom Dominik
VMXpert Performance Products
//www.vmxpert.com
Longmont, Colorado

Dom