Messages

Hello Kevin,

That's what I figured. And your so right, the direction are not too clear. Thank you for taking the time to reply, it's appreciated.

And I also edited my original post, I was typing in "degrees" when I should have been typing "MM BTDC" sorry to all for any confusion.

Hello gentlemen, quick question regarding timing using the HPI ignition on my 76 MC5 400.

The HPI instructions read to line up the rotor line with the large line second from the left on the stator while at 2 mm BTDC. I was wondering if HPI is using the 2 mm number just as an generic starter point due to this ignition being used on multiple bikes.  Meaning should I go ahead and time to 2.4 mm BTDC as stated in the manual and of course using the same marks as called out in the instructions or is the 2 degs the number I need to use?

Thanks for the help, it's appreciated!