Messages

Doug, Thanks for the fedback. I ordered the trans bearings from alan the other day. He mentioned it would be best to stay with the set up I currently have rather than swapping main shafts. I have the larger end one in a set of center cases that need to be welded. The new center cases are the old type with the smaller end main shaft bearing. So I have a brand new set of center cases I can't use. That's the breaks (that need to be heliarched). I'll keep you posted if I run into anything else. Thanks again, Wayne

 

Doug, I've uses Alan Buenher in the past. Would he be a good source to know what I will need? Or whoo else can I find for the parts I will need? Not much to choose from on ebay. Thanks

 

I am in search of help! I have a Wassell motor to rebuild. I just purchased new center cases and they DON'T FIT! The main shaft bearing is the smaller one from my motor. Can I just replace the main shaft or is there a bearing that would match my shaft (I think I got the shaft) and the new case? What are my option? Thanks for any help.