Messages

email sent

Keith Meatyard

I carried a couple of Jackpiner pipes to a engine rebuild shop and had them place them in their vat overnight. Clean as a whistle, and noe excess heat worries.

Keith Meatyard

Just go to any bearing supply like Motion Industries and get an internal snap ring for retaining the seal OD that you have.

Keith Meatyard

David, I have a right only with the two loops for holding the magneto wiring.

Keith Meatyard

David, the Pirelli MT16 4x18 and 3x21 are similar in size and appearance to the original Metzlers. I used them on my restoration, and they look good.



Keith Meatyard

Is there a way to find the selling price of these Mecum auction bikes after the auction?

Keith Meatyard

Welcome Boyd.  As Cal Alexander mentioned, I live in Seminole, AL which is right next to Pensacola. My contact info:
[email protected]
251 946-3308

Keith Meatyard

Mike, call me at the above number or email the best way for me to contact you.  I haven't found a MT08, so the 13 may have to do.  At least it is a similar Mototrial family member.

Keith Meatyard

quote:Originally posted by gooddirt

got any motor parts ? need spacer on left side of crank behind the gear. .

Larry, is this the thin spacer between gear and bearing?  I have something in a bucket of engine parts that may be it.  Do you know the OD, ID, and thickness?

Keith Meatyard

CSM Restoration Parts.  //www.ClaussStudios.com

Keith Meatyard

See my post regarding restored parts in the for sale section.  I have the silver clutch cover and a short ignition cover, ready to bolt on.  The original ignition cover for yours would have been the full length.

Keith Meatyard

I have the clutch cover and a short ign cover, both which I restored with correct details, both ready to bolt on.  You can email or call me.  [email protected]
251 946-3308


Keith Meatyard

Rich, the front fender leading edge to front hole in bracket measures 9" with tape laying flat on fender curvature.  The rear measures 8-3/4" from back edge to loop (not the bolt holes) with tape laying flat on fender curvature butted up against the loop.

These were measured on my 73 JP which has it's original aluminum fenders.

Keith Meatyard

Al B sells a nice repo of the tool bag.

Keith Meatyard

Andreas, email or call me.  I have a complete, working when removed Motoplat system from a 250.

[email protected]
251 946-3308

Keith

Keith Meatyard