Messages

Need a short piece about 16" long.  Dent or two ok. Using it on a trials bike.  Prefer 5-1/4, 5-1/2 or even 6" wide.

I never saw one and just thought there should have been something for safety sake.

this photo brought up a question I had on steel tankers.  Was there no front cable guide to keep tire from grabbing cable ?  Seems like there was but can't find any information.

Re-Chromed Ceriani top shock cover in perfect condition $125 plus shipping.
                                                                                                            Rest of the items in photo EXCEPT shock cover are $150 or I can separate if you want.  4 re-plated Head bolts, 2 nos shifter return springs, layshaft thrust washers and bearing and nut, Bosch coil and wire covers, shortened gear shift lever, 4 top shock spring collars, 3 nos sprocket lock plates, brake cam, 2 nos rubber fork stops, 2 trans oil filler plugs, 2 wrist pins used, 1 wrist pin bearing, 1 nos selector key, 1 speedo driven gear, 2 nos clutch adjuster plates with both screws, 2 handlebar u bolt saddles, 1 nos Bing carb clamp, 1 fork gator top spacer.  Ted Atkinson Canal Winchester, OH  43110  I take Paypal.
All items SOLD. Thanks

Seems strange that the taillight had 2 filaments but no switch was thought of. Several mistakes like same part number on frames, even though the 002 shows the mount for a low pipe. What does the switch look like and what brand for a 72?

Did Penton ever supply a brake light switch for the enduro kits 68-71?  If so what brand was it and what did it look like? Thanks all.

thanks Al.

Did any and if so which, model Penton, ever use a trapdoor made for (2) cables?

Used Bosch stator $100  SOLD  / NOS CEV 150mm flat back headlight shell complete with wiring, high beam bulb indicator etc SOLD.    150mm CEV headlight rim and used seal beam original SOLD.     / NOS Sachs radial fin head for cast iron cylinder made for 60mm 152cc mod best offer.   / ZKW NOS switch with wiring pigtail and a genuine wiring loom (used in EC) for lighting for steel tanker.     / Speedo mount NOS for cross bar VDO  SOLD     /Will post photos on Penton Facebook site. Make offer if you want. Clearing out steel tank items. Ted Atkinson  CW, Ohio

Thanks all.  Must have been husky stand.

Anyone remember a simple engine stand that came with Penton or maybe Husky dealer tool collection?  It was about 16" long x 5" wide and about 3/4" thick? This is by memory.  Had 4 round posts sticking up.  You would lay engine on it's side and posts went thru motor mounts. 

Anyone have contact information for Jan?  Believe he was from the Czech Republic.

Kevin:  Is the 14mm the ones used on the original Sachs 100/125's? I have a perfect re-chromed original I was going to use for a resto that never happened.  I'll have to look but think it is the straight variation not with the dogleg.  Email me as I'm not on this site that often.  [email protected]   Ted Atkinson

Thank you!

Cal: Who do you use for zinc?