Why would you think a low production bike that's is a milestone model is not desirable .. pretty funny ...I have been offered 6k for mine and have other collectors waiting for me to sell it if do.
- Welcome to Penton Owners Group.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
#2
Penton Talk / PVL Rotor number.
June 17, 2020, 06:30:36 PM
D 7 and below that is 919 to the right of the PVL logo
#3
Penton Talk / Witch Mikuni carb.shoud I get.
June 11, 2020, 04:24:49 PM
use clear fuel line and check gas flow from petcocks...
#4
Wanted / For Sale / WTB 14mm Kick Start Lever
May 19, 2020, 02:30:31 PM
ANY shaft will be lager in the OD any lever will be smaller ID- the lever is 12mm ID the shaft is
14mm OD
14mm OD
#5
Penton Talk / TIRE CHOICE 77 KTM 125 MC-5
October 24, 2017, 02:04:49 PM
Duro or VEE rubber brands, forgot the ID#s
#7
Penton Talk / Sachs Ignition Crank Pin Question
September 05, 2017, 03:58:04 PM
They are pressed only on the -A- motor. The -B- motor is part of the crank; one unit, Al needs to know this ... suppose it could be machined to work.
#8
Wanted / For Sale / Liquidating Penton Bikes, Parts, Tanks
July 29, 2017, 12:39:39 AM
I have a 9-73 and its a gold tank black motor and 73 pipe bike....
#9
Wanted / For Sale / Special KTM Tuning for Sachs Engines
July 28, 2017, 12:11:52 AM
I have the Tuning and most of other decals..
#10
Wanted / For Sale / Wanted: kicker and side panel
June 23, 2017, 07:56:47 PM
The early 1974.5 had the 1974 alloy cover and were bent outward for the lay down.
#12
Penton Talk / Swing arm fractures
March 25, 2017, 02:58:34 PM
I have a Spring Sale on Swinger's this weekend.
#13
Wanted / For Sale / Crankcase ignition wire rubber grommet pops out
March 24, 2017, 01:38:16 AM
rotate the stator for final timing ; after you have found the right slots in
the plate then tighten it down . lightly loosen the three center screws on the stator and put on the fly wheel and insert the timing pin and rotate to your setting. remove fly w and tighten the screws
the plate then tighten it down . lightly loosen the three center screws on the stator and put on the fly wheel and insert the timing pin and rotate to your setting. remove fly w and tighten the screws
#14
Wanted / For Sale / Wanted penton trials/wassell front fender mount
February 17, 2017, 05:14:17 PM
One of the suppliers on the home page should have it ; if Paul does not.
#15
Wanted / For Sale / Penton Trials Rolling Frame
February 17, 2017, 05:08:52 PM
Was this the same bike for $200 a few weeks ago on craigs list?